Answer: Check the state of fixation of the tool and the stability of the workbench to make sure that the tool and workpiece are installed correctly. Also check if the speed of the spindle and the feed speed match.

Answer: A problem is possible with the calibration of the machine. It is recommended to re -calibrate the coordinate system of the machine or check the settings of the processing program parameters.

Answer: Check the spindle lubricant system to make sure that the amount of lubricating oil is enough and the lubricant path is free. If necessary, stop the machine to cool the spindle.

Answer: Perhaps the feed speed or cutting speed is inappropriate. It is recommended to adjust the processing parameters or choose a more durable tool.

Answer: Make sure that the tool is sharp, use the appropriate lubricant-cooping liquid and make sure that the workpiece is securely fixed.

Answer: Check the alarm codes usually associated with programming errors, the machine restrictions or the malfunctions of the sensors to determine the specific problem and eliminate it.

Answer: optimize the processing path, reduce air cutting time and adjust the feed speed and cutting depth to increase processing efficiency.

Answer: Check the condition of the tools of the tool store, make sure that the instrument position sensor works correctly, and perform the necessary calibration.

Answer: Vibration can be caused by a too high feed rate or inappropriate workpiece material. Adjust the feed speed or select a more suitable processing strategy.

Answer: Check the condition of the tool for changing the tool and the serviceability of the instrument store position sensor. If necessary, clean or replace the sensor.

Answer: Check the puff of the clamp so that the workpiece does not shatter and does not shift during processing, and if necessary, use more durable clamps.

Answer: Perform a re -calibration of the coordinate system of the machine and check the condition of the lattice ruler or encoder to make sure that it works correctly.

Answer: Restore the control system, check if there are cliffs of wires or short circuits, and also check whether the software version needs to be updated.

Answer: Check the instrument cooling system, make sure that the lubricant-cooping liquid is used correctly, and adjust the processing parameters in accordance with the characteristics of the material.

Answer: Perform regular maintenance and calibration, as well as check the wear of the main components, such as guides and screws.

Answer: Perhaps the cutting power is too large or the workpiece is not firmly fixed. Adjust the processing parameters or improve the design of the device.

Answer: Check the spindle drive system and power lines to make sure of the correct operation of the electrical components and eliminate problems with overload protection.

Answer: Use more acute tools, adjust the cutting parameters or use tools to remove burrs for post -cutting.

Answer: Perhaps poor lubricant or untouched details. Check the lubrication system and mechanical connection of the machine.

Answer: Check the correct path of the program and make sure that the positions of the workpiece and tool are set correctly to avoid programming or operation errors.